Poulan Pro P3818AV Chainsaw Manual

The Poulan Pro P3818AV is a powerful chainsaw designed for homeowners and professionals alike. It features an 18-inch bar and chain, a 38cc engine, and an automatic oiling system for smooth operation. This manual provides essential information on safety, features, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Safety Information 3. Operation Instructions 4. Specifications 5. Maintenance 6. Troubleshooting

Features at a Glance

Key features include: 18-inch bar, 38cc engine, automatic oiling system, and lightweight design for easy handling.

Feature	Description
Engine	38cc 2-cycle engine for powerful cutting performance
Bar Length	18 inches for versatile cutting
Oiling System	Automatic oiling for smooth chain operation
Weight	Lightweight design for easy maneuverability
Safety Features	Chain brake and low kickback chain for user safety

Safety Information

Always wear appropriate safety gear, including gloves, goggles, and hearing protection. Ensure the area is clear of obstacles before operating the chainsaw.

Read the manual thoroughly before use.
Keep hands and feet away from the cutting area.
Do not operate in wet conditions.
Ensure proper maintenance for safe operation.

Operation Instructions

To start the chainsaw, follow these steps:

Ensure the chainsaw is on a flat surface.
Engage the chain brake.
Prime the fuel bulb.
Pull the starter cord to start the engine.
Release the chain brake to begin cutting.

WARNING! Always ensure the chainsaw is properly maintained for safe operation.

Specifications

Engine Type: 38cc 2-cycle
Bar Length: 18 inches
Weight: Approximately 10 lbs
Fuel Capacity: 12 oz
Oil Capacity: 6.8 oz
Chain Speed: 20 m/s
Noise Level: 110 dB(A)

Maintenance

Regular maintenance is essential for optimal performance. Follow these guidelines:

Clean the air filter regularly.
Check and adjust the chain tension.
Sharpen the chain as needed.
Inspect the bar for wear and damage.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Chainsaw won't start	Fuel issue	Check fuel level and quality; ensure proper priming.
Chain not moving	Chain tension	Adjust chain tension; check for obstructions.
Excessive vibration	Worn chain	Inspect and replace chain if necessary.
Oil leaking	Seal issue	Inspect seals and replace if damaged.

Service: For further assistance, contact customer support.